8
F2500 Regency Freestanding Woodstove
installation
tooltip
Blanking Plate
Bolt
Knockout
Shown with Classic door
Pedestal Assembly Installation
1. For easier assembly, tip the stove on its back
(onto a soft surface to prevent scratching) and
remove the front cover.
Hint:
If you have chosen the Ash Drawer op-
tion, remove the ash dump cover plates before
attaching the pedestal (refer to the Ash drawer
Kit Installation section).
2. Important: Remove the blanking plate if:
a) you are not installing outside combustion
air or
b) outside air is to be brought in from the rear
of the stove (see below).
3. Using the 4 supplied 5/16" bolts in the under-
side of the stove, insert the bolts loosely onto
the threads located at all 4 corners at the base
of the unit. Align the holes in the corners of the
pedestal top with the corresponding bolts in the
base of the stove. Tighten each bolt from inside
the pedestal.
1. Push the Regency logo into
the two holes in the front
bottom left corner
of the pedestal
cover plate.
Note: Any paint touch up should be
done prior to placing logo on
pedestal.
2.
If not using ash drawer, then the front cover
must remain in place. If using ash drawer,
then remove the front cover.
Logo Installation
Bottom Heat Shield and Legs
Installation
The instructions below apply to the painted cast
leg. It will be easier to attach the legs to the stove
if the stove is tipped on its back (preferably on a
soft surface to prevent scratching). Ensure to be
extremely careful when tipping stove.
Important: Prior to installing the bottom heat
shield, remove the 4 inch blanking plate. See
below.
This must be removed for combustion air to
enter the appliance.
1. Remove the bolts from underside of the base
of the pedestal (if installed) and discard. Also
remove cover plate and put to the side.
2. Line up the heat shield with the bottom of the
unit.
3. Start threading the bolt and washer (washers
may be square/round) (supplied with the bottom
shield) for about 1/4 of the way through the leg
with the washers being underneath the legs.
Ensure that the legs are properly aligned with
heat shield and tighten the bolts.
4. Level the stove by adjusting the levelling bolts
in the bottom of each leg.
5. Reinstall cover plate if not using ash drawer
option.
6. Install logo plate onto heat shield by placing in
2 holes as shown in diagram.
If you are installing outside combustion air, bend
the tabs out 90 degrees. Pipe fresh air into the bot-
tom shield by using a minimum 4" duct pipe with
a mesh grill at the outside termination. Attach the
pipe to the 2 tabs with screws.
Bottom Shield
Cover
Plate
Tabs
Spacer
Leg
Leveling Bolt
Washer
Logo
Plate
Bolt
Screw
Blanking Plate
