Regency P48 Zero Clearance Direct Vent Gas Fireplace
22
IMPORTANT
Dangerous operating conditions
may occur if the panels are broken.
BRICK PANELS
1) Unhook the 2 spring loaded hooks from the bottom of the flush door
and lift the Flush Front off the unit.
2) Unwrap the brick pattern panels from the protective wrapping.
Note: The logs must not be in the unit.
3) Insert the back brick panel first by carefully slipping it between the
back wall of the firebox and the rear log bracket.
4) Put the side panels in next. Tilt them in towards the middle of the
firebox and put the bottom front corner in first. Be very careful not
to scratch them on the firebox hardware. Place them flat up against
the wall, they should fit snugly against the top of the firebox.
INSTALLATION
5) Install the 2 brick retaining clips, one on each side.
NOTE: If the bottom brick panel must be removed:
Remove the grate, then remove the Burner
Tray. See the instructions on page 37.