10
Regency I31-2 Gas Fireplace Inbuilt
FLUSH FRONT
INSTALLATION
1)
Install Logs before going on to the next
step. See the Log Installation instruction
sheet or page 8 in the manual.
2) Install the bottom glass trim by hooking the
trim into the lip on the firebox base. The trim
will not fit into place if the glass is installed
first.
Diagram 1
Diagram 3
Diagram 4
FACEPLATE & TRIM
INSTALLATION
1) Lay the faceplate panels flat, face down on
something soft so they don't scratch.
2) Take the top faceplate and align the holes
in it with the holes in the side panels. Using
the screws provided, attach from the top
of the panel (the holes in the top panel are
slightly larger than the holes in the side
panel to facilitate easier installation). See
diagram 1.
Diagram 2
Rear View: Trim Assembly
Diagram 5
Hint: Don't tighten the trim to the bottom of
the faceplate side panels with the screws
provided. See diagram 1.
3) Using the connectors provided, join the left
side trim (with the ON/OFF switch) to the top
trim. Connect the right side trim to the top
trim.See diagram 2.
4) Place the trim on the assembled faceplate
panels, aligning the wire connections from
the switches with the notch on the left side
panel.
5) Hookup the 3 Fan Switch wires to the fan
switch on the left side trim. Diagram 3.
WARNING: The 3 wires are to the
Fan and the 2 wires are to the ON/
OFF burner switch. DO NOT con-
nect to the wrong switch.
WARNING:
Ensure that the wires do NOT
touch the firebox
INSTALLATION
6) Connect the 2 burner ON/OFF switch wires
by taking the yellow and orange wires with
the female ends and connecting them to the
burner ON/OFF switch.
7) Tuck the wires into the faceplate to keep
them away from the inbuilt fireplace using
the clip provided. Attach the clip to the rear
of the faceplate to ensure that the wires do
not touch the side of the unit. See diagram
3.
8) The power cord should be run behind the
faceplate panel.
9) Attach the brass trim to the faceplate by
drilling a 1/8" hole through into the faceplate
using the hole in the trim as a guide. Fasten
the trim to the faceplate panels using the
plated screws. See diagram 4.
10) Attach the faceplate panels* to the inbuilt
fireplace body using the 4 remaining black
screws. See diagram 5.
11) Push the Regency logo plate into the two
holes in the bottom left corner of the face-
plate. See diagram 4.
Summary of Contents for I31-2
Page 24: ...Printed in Canada...
