17
Regency F28/F43 Freestanding Gas Heater
5
) Carefully remove the logs, embers and
rockwool.
6)
At this point you should disconnect the gas
at the valve.
7)
Remove the burner by removing the four
1/4" hex head screws. See diagram below.
Note: Use a magnetic type screwdriver.
F43 burner
F28 burner
REMOVING VALVE
If your valve requires maintenance or replace-
ment, follow these instructions:
NOTE: Always shut off the gas supply
before
removing the valve.
1)
Open front pedestal door and unhook chain.
You may want to put a soft cloth on the base
of the unit so that when the pedestal door
is open it doesn't scratch the paint. See
diagram below.
2)
undo the six screws holding the control
MAINTENANCE
panel in place.
3)
Disconnect all wires from the back of the
panel and then remove panel. You should
lay the panel on a soft cloth so it doesn't get
marked up. See diagram below.
4)
Remove the two outside frame pieces by
removing two screws per side. See diagram
below.
8)
Remove eight 1/4" hex head screws holding
the burner tray assembly in place.
9)
Carefully lift the burner tray assembly out.
10)
To replace the burner tray assembly, simply
reverse these instructions.