16
Regency F28/F43 Freestanding Gas Heater
MAINTENANCE
To remove F28 fan:
1)
unplug or disconnect power source to stove.
2)
Remove all logs and the rear log support,
then remove the 10 screws holding the ac-
cess panel in place, see Diagram 2. (Fan
can also be accessed from the right side by
opening the right side door. See Diagram 1).
3)
Unclip the black, red and white wires from
the fan motor.
4)
Lift fan off of the 2 pins, tip back and pull
through firebox opening. Disconnect the
green ground wire from the left side of the
fan as soon as you can reach it.
Replacing F28 Fan:
Diagram 1
Diagram 2
Hint for pushing fan down onto pins - rub a bit
of dish soap on the pins so the grommets will
slide down more easily. Check to make sure
the fan is seated properly on the pins - try to
move the fan back and forth, there should be
no noise, if there is check that the grommets
haven't come loose.
1)
unplug or disconnect power source to stove.
2)
Remove all logs and the rear log support,
then remove the 6 screws holding the access
panel in place.
3)
Disconnect the molex plug.
4)
Remove the green ground wire from the fan
body.
5)
Lift fan off of the 2 pins, tip back and pull
through firebox opening.
Replacing F43 fan:
Reverse steps (1-5 on removing the fan). If
necessary install a new gasket (Part# 936-196)
before replacing the fan access panel. Make
sure the fan wires are reattached.