16
|
Regency CS1200 Freestanding Wood Stove
|
16
installation
Side View
Front View
Front View
1)
If the two air tubes are installed continue on to Step 2), if not, follow the
instructions below. Install the air tube into the holes in the side channels.
The notch goes on the right hand side with the air holes facing toward the
door. Slide the tube into the left hand side, as far as possible and then
bring it back into the hole on the right hand side until it locks into position.
If the tube will not slide in easily simply use a pair of vise grips or pliers
and tap it into place with a hammer. A tighter fit will ensure the tube will
not move when the unit is burning. Refer to the Mobile Home Installation
section, though there are only two air tubes in the small units.
2)
Slide the left baffle brick over the front air tube and then slide it back over
the rear air tube.
3)
Tilt the left baffle brick up on top of the side channel and it will leave enough
room to position the right baffle brick in the same manner as Step 1 above.
Then reposition the left baffle brick flat on the air tube.
The door handle can be removed and stored on a hanger located on the
inside left in the wood storage area.
4) Important: push both baffle bricks so they are tight against the side
walls.
Note: When getting the chimney cleaned, remove the baffle bricks for
access to the flue, then replace them when cleaning is completed.
BRICK INSTALLATION
Firebrick is included to extend the life of your stove and radiate heat more
evenly. Check to see that all firebricks are in their correct positions and have
not become misaligned during shipping.
The "AD" brick in the drawings above is the brick covering the Ash Dump hole
that is used when the Ash Drawer Kit is installed.
DOOR HANDLE
AD Brick
BAFFLE AND TUBE INSTALLATION
Handle stored on hangar
in wood storage area.
