12
|
Regency F1100/F3100 Freestanding Woodstove
|
12
installation
Diagram 4
Diagram 2
Diagram 3
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
All units require either the pedestal or 4 legs at-
tached to the base. The F1100 and F3100 stoves
require either the Airmate or Rear Heat Deflector
on top of the stove. Clearances to combustible
materials vary depending on whether the airmate
or rear heat deflector is installed, so be sure to
check the Minimum Clearance to Combustible
Materials section.
Airmate Assembly
for F1100 & F3100
Small 850-105
Large
850-305
1)
The airmate sits on top of the stove with
the slots in the sides fitting over the curved
deflector on the rear stove top. See diagram
1. Discard the Rear Heat Deflector that is
supplied with the unit, it is not required if the
airmate is installed.
2)
Center the airmate and push it forward to the
front of the stove. The back of the airmate
should be level with the back and sides of
the rear heat shield. See Diagrams 2 & 3.
Diagram 1
Shown with classic door
Shown with classic door
Shown with contemporary door
Rear Heat Deflector Assembly
for F1100 & F3100
Small 815-557
Large
815-558
The rear heat deflector is supplied with the stove
and must be installed unless the optional airmate
has been selected. It stops the heat radiated
from the flue collar from overheating the rear
wall. The rear heat deflector is installed on top
of the rear heat shield, as shown in Diagram 4.
Pedestal Assembly
Small 073-925
Large
063-925
1)
For easier assembly, tip the stove on its
back (onto a soft surface to prevent scratch-
ing).
Hint:
If you have chosen the Ash Drawer
option, remove the ash dump cover plates
before attaching the pedestal (refer to the
Ashdrawer Kit Installation section).
2)
Important:
Remove the blanking plate if:
a)
you are
not
installing outside combustion
air or
b)
outside air is to be brought in from the
rear
of the stove (see below).
3)
Unscrew the 4 bolts in the under-side of the
stove. Align the holes in the corners of the
pedestal top with the corresponding holes
in the base of the stove. Fasten using a bolt
and washer for each corner.
4)
Push the Regency logo
into the two holes in
the front bottom
left corner of
the pedestal
cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.
5)
If not using ash drawer, then the knockout
must remain in place. If using ash drawer,
then remove knockout.
