16
CAUTION:
To prevent personal injury or property damage, only unplug
boiling chamber power cord after POWER and FAN switches are turned OFF,
distiller is unplugged from the wall outlet and the unit has completely cooled.
3) Remove the rubber gasket from the boiling chamber. Clean the gasket
with a mild detergent, rinse and dry thoroughly.
4) Dispose of the water and residue from the boiling chamber and wipe
with a cloth and clean water.
To avoid risk of electrical shock, do
not immerse the boiling chamber in water or any other liquid
for cleaning.
5) Clean the boiling chamber by combining two cups of white vinegar and
enough warm water to fill the boiling chamber. Allow this solution to sit
in the boiling chamber for at least six hours, or preferably overnight.
Commercial descalers or kettle cleaners may be used in place of the
vinegar following the manufacturer’s instructions.
6) Dispose of the cleaning solution and rinse the boiling chamber
thoroughly with clean water.
DO NOT IMMERSE
. If stubborn scale
deposits remain they may be removed with a nylon scouring pad. Then
wipe the boiling chamber thoroughly with a cloth and clean water . Do
not tap on the heater to remove deposits. Tapping on the heater may
damage it.
7) Replace the gasket on the boiling chamber and reassemble to the
distiller unit (see page 12), tightening the lid with the lid cover knob.
Plug the boiling chamber power cord into the receptacle and then plug
the distiller back into the wall outlet. Your distiller is now ready to
continue providing you with fresh distilled water.
RESERVOIR
It is recommended that you steam clean your distiller and reservoir once
every 6 months (see page 6 for instructions). If your distiller has a demand
pump, turn the POWER OFF and unplug the pump.
OUTSIDE SURFACES
Your distiller has been designed to require minimal maintenance. The
exterior of the distiller and reservoir tank may be wiped with a soft cloth or
sponge dampened with warm soapy water. A commercial glass or stainless
steel cleaner may be used to maintain the luster of the exterior. Do not use
abrasive or solvent based cleaners. DO NOT SPRAY CLEANING PRODUCTS
DIRECTLY INTO THE DISTILLER OR RESERVOIR.
The distiller’s cooling system vents (see page 5) should be vacuumed
occasionally or cleaned with a soft brush to remove dust and debris. The
distiller must be shut OFF and UNPLUGGED during this procedure.
Do not attempt to clean the condensing coil, contact your
authorized distributor for assistance.
