DO'S AND DON'TS
-NEVER connect both the upgrade power supply box and the Rega PS1 power supply to
the turntable at the same time - this may damage the TTPSU unit.
-Do not unplug the power supply from the turntable whilst the unit is on - turn off the
power supply before unplugging.
-Do not operate the power supply without the turntable connected.
-As you would expect there is a 24V AC plus a 20V DC signal present on the pins of the
plug - if these are shorted it will cause damage to the power unit.
The TT PSU incorporates resettable fuses in the driver amplifier to protect it from over
current faults, which will cause the turntable to run erratically or not at all. If in the rare
circumstance these are activated, they are reset by turning off the TTPSU by the front
panel for approximately 10 seconds. If the fault should persist consult your dealer.
POWER SUPPLY SPECIFICATIONS
PS1 (UK)
Input...............................................................................................................................................230V ~ 50Hz 0.05A
Output..................................................................................................................................................24V ~ 300MA AC
PS1 (EU - Euro 2 pin)
Input...............................................................................................................................................230V ~ 50Hz 0.05A
Output..................................................................................................................................................24V ~ 300MA AC
PS1 (UL - American)
Input......................................................................................................................................................115-120V ~ 60Hz
Output..................................................................................................................................................24V ~ 300MA AC
