48
REFUsol 48K-UL
REFU Elektronik GmbH
6.7
Portal Monitoring
To ensure the inverter sends data via Ethernet to the REFUlog monitoring portal, the portal monitoring must
be active.
Open Menu Configuration > Portal Monitoring and enter the following value:
0 = Portal monitoring via Ethernet not active
1 = Portal monitoring via Ethernet active
Pos : 68 /I nverter M anuals/ Konfig urati on/Konfig vers endung/ WR @ 1\ mod_1405076710098_641. doc x @ 7162 @ 2 @ 1
6.8
Sending Config
Menu Configuration > Portal monitoring > Config sending
The configuration data is required by REFUlog in order to recognise the inverter. If you want to send it
manually, select the menu and set the parameter to 1. If the sending was successful, the parameter will be
set back to 0 automatically.
Pos : 69 /I nverter M anuals/ Konfig urati on/Port al T estf unkti on/WR @ 1\ mod_1405076841099_641. doc x @ 7168 @ 2 @ 1
6.9
Portal Test Function
Menu Configuration > Portal monitoring > Portal Test
On request of our service, you can send a test data package to the portal. Open the
Pos : 70 /I nverter M anuals/ Betrieb/ St andar dbetri eb/Arc Fault D et ecti on/Übersc hrift/ O per ating the Arc F aul t D etection U nit @ 2\ mod_1475849172187_641. doc x @ 25024 @ @ 1
Notice
If the inverter is connected with RS485 to REFUcontrol, the setting 0 (Portal
Monitoring via Ethernet not active) must be used!
