Reflexonic® Viberect®
Page 4 of 16
VIBERECT X3 User Guide 2014-Rev-0
BATTERY
The battery in your
Viberect
®
has not been charged prior to
delivery.
A completely discharged
battery will take approximately
6-8 hours to fully charge. The
Red charge indicator will
extinguish once the charge
cycle has completed.
To ensure that your Viberect
®
is always ready for use, it is
recommended to recharge the
battery after use. Do not
leave the device on charger
mode for more than 8 hours.
A fully charged battery will
allow about 30 minutes of
vibration at medium frequency
setting.
When completely discharged,
allow 6-8 hours to recharge.
Ensure that the vibrator is
turned off before recharging.
Use only the charger supplied
with the vibrator. Charge the
Viberect while laying it on its
side so the two arms are not
brought together by gravity
which may turn the device on.
DO NOT ATTEMPT
to use
the device while charging.
Disposal of the battery
The rechargeable battery in the
vibrator contains Nickel Metal
Hydride (NiMH).
Like other batteries of this type, if
burned or punctured, it could
release toxic material which could
cause injury.
Device has no replaceable internal
power source. Batteries cannot be
replaced by the end user. If you
wish to dispose of the device, do
not disassemble components.
Discard in its entirety.
Check with local solid waste
officials for details concerning
recycling options and proper
disposal. In the United States, call
toll free 1-800-8-BATTERY or visit
the Battery Recycling Corporation
website at
http://www.call2recycle.org/
The life of NiMH batteries is
strongly influenced by the care that
they receive. If properly maintained,
the battery is capable of more than
500 charge/discharge cycles before
dropping to 80% of capacity. Do not
exceed the allowable ambient
temperatures during charging,
operating, or storage.
WARNING
No modification of this equipment is
allowed. If this equipment is modified,
appropriate inspection and testing must
be conducted to ensure continued safe
use of equipment.
PG.4
2216682-A.indd 4
10/24/14 5:52 AM
