Installation Instructions
16K Sidewinder
TM
©
2009, 2016 Cequent Performance Products - Printed in Mexico
Sheet 5 of 12
SW16KIN
10/25/16
Rev. J
Form: F205 Rev A 5-6-05
ASSEMBLY INSTRUCTIONS – CON’T
8. Before attempting to fully tighten the (4) 5/8-11 cap bolts, it is necessary to check that the upper wear disc is
properly positioned. Refer to the figures below (figure 13).
Figure 13
Upper Wear Disc Must Seat Around the
pivot tube of the arm as shown.
•Torque (4) Bolts to 150 ft-lbs to assure turret is fully seated,
then back off fasteners and re-torque (4) Bolts to
45 ft-lbs
.
Figure 14
9. Tighten (4) 5/8-11 cap bolts as shown, repeat pattern 2-3 times.
Repeat pattern 2-3 times
Top Plate
Upper Wear Disc
Note:
Pivot tube is only expected to
exceed height of tube in turret
by 0.125”. (Just enough to
capture a portion of top plate).
