Reely TQ Performance Drone RtF, Operating Instructions Manual

Page: 5 / 32

5
5. Product description
The ready-to-fly “TQ Performance Drone” IR quadrocopter features 4 separately controlled motors, each of which
drives its own propeller. Using the simultaneous acceleration of all propellers, the quadrocopter can lift off from the
ground and, at appropriate propeller speeds, hover steadily in the air.
For in-flight stabilisation, the quadrocopter has sophisticated electronics with position and acceleration sensors (6-
axle gyro) allowing uncontrolled movements of the model to be detected and compensated for immediately. The
quadrocopter is equipped with an air pressure sensor so that it can stabilise its flight altitude itself.
For flight in a given direction, the electronics in the model detect the control impulses of the transmitter and alter the
speeds of the individual motors accordingly. The quadrocopter thus tilts in the desired direction and the lift thereby also
acts as thrust. The quadrocopter flies in the respective direction.
On the model, two propellers turn clockwise and two turn anti-clockwise. Through a targeted change of speed of the
two propeller groups relative to each other (propellers turning to the right turn somewhat faster and propellers turning
to the left turn somewhat slower or vice versa), it is possible to turn (yaw) the quadrocopter around the vertical axis
while keeping the altitude the same and keeping the quadrocopter in the same spot.
The quadrocopter has a green LED at the rear (at the IR receiver) and a white LED at the front to better recognise
its orientation in flight.
For beginners, the transmitter may be operated in beginner mode. In beginner mode, the control reactions of the
model are significantly reduced (dual rate function). In sports mode, the quadrocopter reacts with much greater agility.
The quadrocopter has maximum control sensitivity when in expert mode.
If necessary, the quadrocopter can perform roll-overs (flips) in any direction.
To operate the transmitter, 3 AAA/Micro batteries are required (not included and must be ordered separately).
Please use batteries only instead of rechargeable batteries for operating the IR transmitter.