18
16. Switching the Digital Code
The transmitter enables you to control receivers with the digital code „AFHDS“ and „AFHDS2A“. Ex works, the trans-
mitter is set to the enclosed „AFHDS2A“-encoded receiver.
If you want to operate a REELY receiver with the digital code „AFHDS“, the transmitter must be switched first and then
the receiver must be bound to the transmitter (see following chapter).
To switch the digital code at the transmitter, proceed as follows.
•
Switch off the transmitter.
• Move the steering wheel for the steering function (see figure 1, item 2) to one side to the stop and keep it there.
• Push and hold the binding button (see figure 2, item 14).
• Switch on the transmitter with the on/off switch with the steering wheel deflected and the binding button pushed.
•
Release the steering wheel and the binding button.
• If the green LED for undervoltage is flashing continually, the transmitter has switched to the digital code „AFHDS“.
If the green LED is flashing with interruptions, the transmitter has switched to the digital code „AFHDS2A“.
•
Pushing the binding button again saves the currently set digital code.
•
Switch the transmitter off and then on again so that it sends in the set digital code.
Important!
The receiver enclosed with the remote control system „GT2 EVO“ works with code „AFHDS2A“. Therefore,
always observe that the right code is programmed at the transmitter!
