19
b) Programming of Transmitter Channels (General)
Before you begin programming, unplug the re-
chargeable battery, if connected, from the
QuadroCopter. Also disconnect the connection ca-
ble to the PC, if connected, from the QuadroCopter.
Use a jumper for the RC configuration setting “R2”
for “remote setting” (5). You will find the plug con-
nectors for the jumper in the right upper area on
the reverse of the control board of the
QuadroCopter.
On one side of the board (1), both of the LEDs (2)
indicate particular operating statuses. On the op-
posite side of the board (3), the plug connectors
“S1, S2, R1, R2” (4) for the jumpers are to be seen.
To operate the QuadroCopter in “remote setting” mode, affix the jumper “R2” (5) as shown in figure 8. This setting is
independent from other affixed jumpers.
Important!
Before switching the transmitter on, please set the throttle stick to “motors off” and all trim levers / trim
sliding controllers of the pilot stick to the neutral position. Otherwise, the QuadroCopter may not recognise
the transmitter after the battery is connected.
Now switch on the transmitter and pull out the telescopic aerial of 27-/40 MHz remote control systems completely.
Please ensure that all levers and trims of the transmitter are in neutral position. The examples given show the proce-
dure using a remote control in mode 2. If you prefer to use another mode, the used axes may differ (see chapter
“Possible Flight Modes”)!
Please also ensure that the sliding controller for the trim is set to neutral position! Otherwise correct recognition of the
channels will not be possible!
Please also ensure that lever movements are made
in the right direction, otherwise the signals will be
memorised in reverse! Computer remote controls
should always be operated without mixer!
Move the throttle lever (see figure 9) backwards to
the neutral position (motor off), all other control
devices should be set to neutral.
Do you want to try out “pitch reverse”? (during “mo-
tor off” the pilot stick for throttle is pulled away from
the body), then bring the throttle lever forwards into
the max. position before you connect the recharge-
able battery.
Figure 8
Figure 9
Summary of Contents for QuadCopter 650 ARF
