Series SD10000 Spring Driven Reels
www.reelcraft.com
Page 5
Fig. 2
Spring Canister
To replace the spring canister, follow the steps below.
Do not attempt to service the spring inside the spring canister.
Warning:
The only service you should perform on the reel spring is replacing the spring canister. The spring is under
extreme tension and could be propelled out of the opened canister and cause serious injury.
1. Relieve the pressure and bleed the line of all fluid. It is recommended that the supply line be removed from the supply
source to eliminate the possibility of pressurized fluid injuries and/or accidental spills.
2. Remove dispensinge valve and bumper stop.
3. Unlatch reel and let the reel unwind fully to a free state before beginning disassembly. Do not allow the reel to unwind
unassisted. You risk damage to the hose threads, reel and personnel.
4. Remove the four 1/4”-20 nyloc nuts holding the spring and case assembly to the side frame.
5. Pull the spring and case assembly free from the side frame as shown in Fig.3.
6. Locate the new spring case and take note of the location of the “hook” on the end of the spring as shown in Fig.4.
7. Attach new spring and case assembly to side of the reel aligning the female hook of the drive spring to the male hook
on the arbor.
8. Replace four 1/4”-20 nyloc nuts and tighten securely.
9. Follow adjusting spring tension instructions above to properly tension the spring for your application after replacing
the spring.
Service Instructions
