IMPORTANT NOTICE
This pump is not suitable for
outdoor use it must be protected
from the weather by way of a
weatherproof enclosure. Failure to
do so voids all warranty.
This pump must not be run dry, it must be installed using
barrel-union connections, by a licenced person who is
authorised to install this type of device. It MUST be installed
so that if it were to leak, fail to operate, or run without
stopping, that it would NOT cause damage or loss. It must be
connected to an electrical circuit with an RCD (Safety Switch)
having a rated residual operating current not exceeding
30mA. Disconnect pump from power before servicing or
repairing the pump. Read and follow the instructions,
warranty is void if instructions are not followed.
IMPORTANT!!
The pump bearing is lubricated by the pumped water. This pump cannot run dry
for periods exceeding 10 seconds. Do not pump any flammable or corrosive liquids.
DANGER!!
USE FOR CLEAN FRESH WATER ONLY WITH MAXIMUM TEMPERATURE OF 60°C!!
You MUST bleed the air out of the pump before turning on the power!
