9
Operating Instructions
Power ON/OFF
Press the POWER button to turn the meter on or off.
Setup Mode
1.
Once the software has been installed, connect the R5003 to an
available USB port on your PC with the included USB cable and
power on the meter.
2.
Double click the SOFTWARE icon on your desktop and the program
will load.
3.
Set up the data logger for a new session (see
Software Operating
Guide
for details).
4.
When setup is complete, the R5003 should be removed from the
USB port in order to preserve battery life.
5.
Connect the voltage test leads or the current probes to the AC
source, or clamp the jaws around a single conductor for AC current
measurements from 10 to 200A.
6.
Press and hold the
START/STOP
button for four seconds to start
recording. The REC icon will appear in the display indicating that
recording has begun.
7.
Press and hold the
START/STOP
button for four seconds to stop
recording. The REC icon will disappear from the display.
Note:
Recording cannot be paused or restarted until the previous data is
downloaded to the software and a new session is set up. Furthermore,
recording will automatically stop when the memory is full. When
continuous recording is selected (via the software), newer data will
overwrite the oldest data when the memory is full.
8.
When testing is complete, remove the sensors or probes, connect
the data logger to a PC and use the supplied software to download
the data.
MAX/MIN
Press the
MAX/MIN
button to display the Maximum and Minimum AC
current or Voltage values recorded during the measurement process.
1.
Press the
MAX/MIN
button once to display the maximum value.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com