3
Product Quality
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet stated product
specifications. If a certificate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
Safety
• Never attempt to repair or modify your instrument. Dismantling your
product, other than for the purpose of replacing batteries, may cause
damage that will not be covered under the manufacturer's warranty.
Servicing should only be provided by an authorized service center.
• Do not operate around explosive gas, vapour, or dust.
• Do not operate with any of the parts removed.
• Do not use if the unit looks damaged.
• Pay attention to avoid short circuits when testing a non-insulated cable.
• Never open the battery cover during measurements.
• Do not install substitute parts or make modifications on the meter.
• Never replace the battery in moist areas.
• Ensure the meter is disconnected and switched off before opening the
battery cover to replace the battery.
• Do not place the instrument in high vibrating areas.
• Do not expose the meter to direct sunlight, high temperatures or high
moisture environments.
• Switch off the meter after each use.
• Remove the AAA batteries if the meter will be stored for long periods
of time.
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com