7
Maximum Measurement Mode
1.
Press the
MAX
button to enter the maximum value mode.
2.
The Max Indicator will appear on the display.
3.
Hold the durometer vertically with the point of the indenter at least
12mm from any edge.
4.
Place the presser foot onto the test piece while keeping the foot
parallel to the surface.
5.
Apply enough force to ensure proper contact between the presser
foot and the test piece.
6.
Keep in place and Hold for approx. 2 seconds.
7.
The LCD will display the measured maximum value and will hold
this value.
8.
To take the next maximum value, press the
ZERO
button to clear
the reading.
9.
Repeat steps 3 through 8 for each maximum value measurement.
10. Press the
MAX
button to exit maximum measurement mode and
resume normal operation.
Average Measurement Mode
The average value is calculated using the number of test measurements
the user selects which can range from 1 to 9.
1.
To set the amount of test measurements required during a test
session, hold and release the
button to enter the average
measurement mode.
2.
The display will indicate "N" confirming it is now in average
measurement mode as well as the number of set test measurements.
3.
Press the
button again to scroll through the required number of
test measurements ranging from 1 to 9.
4.
Press the
ZERO
button to confirm the selected number of
test measurements.
5.
Press the
MAX
button to begin.
6.
Hold the durometer vertically with the point of the indenter at least
12mm from any edge.
continued...
www.
GlobalTestSupply
.com
Find Quality Products Online at:
