www.reechcraft.com/powerlift
888-600-6160
55
SECTION
7
SERVICE & MAINTENANCE
1. Mast Track Wear
Check that the track is not worn (5 mm tooth remaining) and that the galvanized
surface is in good condition and no corrosion or excessive rust is present.
2. Mast Track Misalignment
Be sure that the track is aligned properly at the joint location. If the track is bent
or damaged in any way, it must be replaced by a qualified mechanic before
machine use may resume.
3. Mast Connector Wear
Mast Track misalignment may be due to worn or damaged coupling pins
located in the Mast Connector. If any part of the connector is worn or and
excessively loose when properly coupled and locked together, it must be
replaced before machine use may resume.
Figure 7-1
Mast / Track Alignment
Wear (5 mm)
Bent, Misshapen
Connector Wear
.020
5 mm
.75 mm
