PowerLift
by ReechCraft
30
Because the ReechCraft PowerLift is a modular operator assembled machine,
the platform, each outrigger and mast section can be removed to reduce weight
as the situation requires.
NOTE:
For the purposes of this section, it is assumed that the machine is in it’s fully
stowed configuration.
Getting Started
1. Place the machine on a firm, stationary surface capable of supporting
the intended load directly under the desired work area.
2. Connect to an appropriate power source. AC: connect to a grounded
15A AC power supply. Be careful the power cord remains slack at
maximum height and does not become entangled in the machine
which may lead to electrical shock or instability.
3. Install front and rear outriggers in their designated positions. Using the
drill and hex driver, level the chassis by adjusting each of the leveling
jacks, until the bubble level is centered. (See Figure 3-3)
secti
On
3
MAChINE OpERATION
3.4
Machine Setup
Figure 3-3 Proper Set Up
