MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
REPLACING ELEMENT
Replacing an old element is a very simple process. All electrical wiring must be carried out by a licensed electrician.
There are Six Basic Steps:
1.
You will need to obtain a 22mm tap spanner.
Remove towel rail from brackets (if already installed).
2.
On the side with the element cable remove push-on cap, and pull element cable through end.
3.
Feed cable through spanner until you reach element hex nut.
5.
Insert new element and screw in place with spanner until tight.
Please note:
Hydrotherm advise that the unit be removed from the wall and turned upside down to ensure that water does not spill.
Ensure element always remains at bottom of Towel Rail if being installed vertically.
- 22mm Tap Spanner
4.
Loosen element with spanner and remove.
6.
Feed element cable back through bracket hole, and refit push-on cap. Towel Rail is now ready be re-installed.
page 4 of 5
