ASSEMBLY
Assembly requires three persons.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key and your own phillips screwdriver .
For help identifying assembly hardware, see the drawings below.
Note: If a part is not found in the part bags,
check to see if the part has been preattached. To avoid damaging plastic parts, do not use power tools for
assembly. Extra hardware may be included.
Latch Bolt (77)–2
1
Upright Bolt (86)–16
1
3/8” Star
Washer (88)–8
5
6
IMPORTANT: Do not extend the Frame (16) past the ver-
tical position before the console base is assembled or
you may damage the gas spring.
1. Identify the Right Upright (95), which has holes in the in-
dicated locations.
Set the Right Upright (95) near the Frame (16) as
shown. Insert the Upright Wire Harness (108) into the
lower end of the Right Upright and out of the top.
Place an elastic band around the Upright Wire Harness
(108) and the Right Upright (95) to keep the Upright Wire
Harness from falling into the Right Upright. Leave the
elastic band on until step 3 is completed.
95
108
16
Holes
Band
1
