5
Solder Bridge Setting
:
1.
VTX – Connect Middle pad and ‘RAW’ or ‘12V’ pad to set VTX voltage to Battery
input and regulated 12V respectively. *Do not short all 3 pads together or very bad
things will happen
2.
CAM – Connect middle pad to ‘5V’ or ‘12V” pad to set CAM voltage. *Do not short all
3 pads together or very bad things will happen
Bottom Buzzer Description
:
A.
Solder a 5V to positive pad
B.
Solder 5V Buzzer - to negative pad
Hold down the Button for 10 seconds upon powering up the RROSD Pro. The LED will turn off to
indicate that the Video mode has been successfully changed
Hold down on the button on The RROSD V2 for 3 seconds to enter into the menu of the RROSD.
To navigate through the menu single click the button to move down an option. Long press to
select an option
RSSI Calibration:
To calibrate your RSSI reading, select the high reading with your radio and
receiver powered on and nearby. Flip off the radio and select the low reading to calibrate the
bottom signal range. *The reading you will see on the OSD is the true received strength of the
signal (more accurate and different from a 2 way telemetry signal being sent from a receiver)
Voltage Calibration:
This menu item lets you calibrate your voltage reading by entering your own
offset.
Current Calibration:
This menu item lets you calibrate your Current reading offset from -20% to
+20%
Set mAH Alarm:
Allows you to set mAh consumption alarm. This will cause the respective
indicator to blink on screen when the desired value is reached. We recommend setting mAH to
80% of the battery capacity
Screen Calibration:
This menu item allows the OSD lines to move from bottom to top
Exit
: Exit the Menu
