13
TO STOP THE SHOWER
Press Button ‘C’
to Stop the shower
(fig.17).
Water will cease to flow and
‘Power’
light will go out.
Expressions Revive-Plus Models Please note that the water
will continue to flow for around six seconds to cool the shower
for the next user.
Switch off the electricity at the ceiling switch or local isolator.
Once a temperature setting to your liking has been achieved, Knob ‘B’ will rarely need adjusting.
You must however take into account required adjustments for variations of incoming mains water
temperature between summer and winter (see ‘Advice to users’ on page.2).
The
‘ECO’
setting of Knob ‘A’ reduces the power used by the shower giving a cooler shower or the
option of reduced water flow.
This option is mainly for summer usage and if this is used then Knob ‘B’, must be re-adjusted.
The
‘COLD’
setting of Knob ‘A’ will supply water without any heating.
During normal operation, if an overheated water temperature is sensed then the heating elements
will be switched off.
The
‘Power’
light will remain illuminated and water will continue to flow and cool down before the
heater switches back on again as the heater automatically resets itself when water has been run
through the shower for a few seconds.
ADJUSTING THE SHOWER HANDSET
To enhance your shower experience your shower has a multi-spray pattern handset and these
patterns can be adjusted by simply rotating the sprayplate.
Each mode is identified by a ‘click’.
WARNING:
DO NOT SWITCH THE SHOWER ON IF YOU SUSPECT IT OF BEING
FROZEN. WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.
DO NOT OPERATE THE SHOWER IF WATER IS DISCHARGED FROM THE
PRESSURE RELIEF VALVE.
MAINTENANCE IS REQUIRED BEFORE IT CAN BE USED AGAIN.
CONSIDERATION SHOULD BE GIVEN TO SUPERVISING THE YOUNG,
ELDERLY AND THE INFIRM WHILST THEY USE THIS SHOWER.
17
