background image

Figure 11.1

MAKE SURE THAT BOTH

SUPPORT TUBES STICK OUT

THE FRONT OF THE STAND

SUPPORT TUBE "C"

3/8 LOCK WASHER

3/8-16 X 1.25" BOLT

3/8 FLAT WASHER

RIVET NUT INSTALLED

IN THE TUBE

Figure 11.2

Figure 12.1

Guide Hole for 3/8" Drill Bit for 

securingthe blind to the support 

tubes as shown in figure 12.3. 

Figure 12.2

STEP 3

: With all 4 Mounting brackets installed, take the Support Tube "C" and place it onto the mounting 

brackets as shown in figure 11.1. Make sure that the long end of the support tube sticks out past the front of the 

stand, see Figure 11.1. With the support tubes in place fasten them into place through the tabs in each bracket 

as shown in figure11.2. Make sure to start the bolts with your fingers so you dont strip out the rivet nuts inside 

the tubes. Once you have them finger tight, fully tighten with a wrench. 

STEP 4

: Once all the arms are in place and secure you can finish building the rest of the stand. Make sure that all bolts 

are tightened and secured correctly. Once the blind is bolted to the platform as called out in the 5' & 10' stand 

instructions, you have the option to secure the blind in 2 more places. Each Support tube has a hole in between the 

Cross tubes. Drill a 3/8" hole through the hole in the tube and through the floor in the blind. Once the hole is in the 

floor you can secure the blind to the support tubes with the hardware supplied with the 6x7 Arm kit as shown in 

figure 14.3.    

Figure 12.3

-4-

Summary of Contents for RD-STD67BR

Page 1: ...l use of the product and contact Redneck Outdoor Products at 877 523 9986 for replacement of missing or defective parts NOTE Some parts of this product are manufactured to be universal in use so there may be some parts containing holes that will not be used in the assembly of this particular model To minimize confusion in the assembly process please read these instructions in their entirety before...

Page 2: ...ER 2 C SUPPORT TUBE 2 B MOUNTING BRACKET 2 A MOUNTING BRACKET 2 BILL OF MATERIALS HARDWARE 3 8 16 BOLT 1 25 LONG 6 3 8 16 NUT 4 3 8 FLAT WASHER 8 3 8 LOCK WASHER 8 3 8 16 BOLT 3 25 LONG 2 THERE WILL BE LEFT OVER HARDWARE 2 ...

Page 3: ...Make sure you only tighten the bolts finger tight while installing Next take the Mounting Brackets A B out of the 6x7 Arm Kit and attach it to the outside of the legs as shown in Figure 10 2 10 3 Fasten these to the stand using the standard hardware out of the stand box Make sure that both brackets are facing in towards the middle of the platform see figure 10 3 Repeat this step for the other side...

Page 4: ...h the tabs in each bracket as shown in figure11 2 Make sure to start the bolts with your fingers so you dont strip out the rivet nuts inside the tubes Once you have them finger tight fully tighten with a wrench STEP 4 Once all the arms are in place and secure you can finish building the rest of the stand Make sure that all bolts are tightened and secured correctly Once the blind is bolted to the p...

Reviews: