SkyKettle RK-G200S-A
9
ENG
3. Start the Ready for Sky app, create an account, and follow the
prompts appearing on the screen.
4. To the standby mode press and hold down button until
three audible signals is heard. The temperature value indica
-
tors will light up alternately during the connection process.
After the connection is made the appliance will make three
short audible signals.
If within 30 seconds the connection won’t be made, the appliance
will make two short audible signals and switch to the standby mode.
5. To disable remote control press and hold until the longer
sound signal. The temperature value indicators will flash
when the connection is broken.
To provide a stable connection, your mobile device should be
located no more than 49 ft (15 meters) away from the appliance.
Bluetooth function
1.
With the power off, press and hold down the
and
buttons
on the control panel of the Kettle, connect the power supply.
2. When Bluetooth is turned on, the indicators will light up alternately
from right to left. After the connection is made an audible signal
will be heard and appliance will switch to the standby mode.
3. When Bluetooth is turned off, the indicators will light up
alternately from left to right. After the disconnection is made
an audible signal will be heard and appliance will switch to
the standby mode.
Water Boiling
1.
Remove the kettle from the base. Press the lid release button.
2. Pour water into the kettle, water level should be between the
MIN and MAX points on the scale. If water level is higher than
MAX point, the boiling water may be splashed. In case of water
undersupply the appliance may be switched off in advance.
ATTENTION! The unit is meant only for water heating and
boiling.
3. Close the kettle lid and set the kettle to the base. The appli
-
ance will be operated only if it is properly fixed.
4. Plug in the appliance. The heating temperature indicators
will flash, the appliance will switch to the standby mode.
5. Press . A short audible signal will be heard, water heating process
will be started, the inner housing illumination will be enabled.
The flask illumination will change the colour during heating.
6. After water comes to a boil three audible signals will be heard,
the flask illumination will go out, the appliance will switch
to the standby mode (no indicator light).
7.
To interrupt water heating process, press again or remove
the kettle from the base.
Water Heating Without Boiling
1.
To heat water without boiling to 100, 130, 160, 185°F (40,
55, 70, 85°C) in the standby mode select the necessary
temperature using (the indicator will light up next to
the selected value), press
.
If the temperature in the kettle is higher than the adjusted heat-
ing temperature three audible signals will be heard after pressing
, the appliance will switch to the Keep Warm mode.
