Redmond RJ-M906, Instructions For Use Manual

Page: 13 / 23

13
IV. TROUBLESHOOTING
V. WARRANTY
The period of guarantee for the product is 1 year from the selling date. The guarantee
covers defects of material and workmanship. Under the present guarantee, the manufacturer
undertakes to repair or replace any part recognized as faulty on condition that the product
is sent to the seller. The present guarantee shall be valid only in case the product was used
in compliance with this instruction, no modifications were made to it, it was not repaired or
disassembled by unauthorized persons, or was not damaged due to improper handling. Also,
the complete set of the product must be retained. This guarantee does not cover natural wear of
the product as well as brittle objects such as ceramic components, lamps, etc. the guarantee
shall not become effective unless the date of purchase is confirmed by the seller’s signature and
seal on the guarantee coupon. Any repair under this guarantee shall not extend the period of
guarantee and shall not initiate the beginning of a new guarantee.
In accordance with p.2 of clause 5 of RF Federal law «About protection of consumer
rights» the manufacturer assigned the minimum service life for this product, which is
not less than 2 years from the date of manufacture, on condition that it is operated in
strict correspondence with the present manual and stipulated technical requirements.
Malfunction Probable reason Remedy
Juicer is not working
The device is not plugged in
The clamps of the juicer are
not ixed.
Plug the device in.
turn off the device irst!
Fix the clamps.
the motor stops during the work
Pulp sticks to the cover
This could be because the
speed is too high or the
pressure on the pusher is
excessive.
Decrease the speed, do not
overload the device with the
produce, use the pusher more
carefully
Pulp sticks to the ilter or pulp
comes through with to much
moisture
Filter hasn’t been cleaned
after the last use.
Wash the cellular ilter with
warm soap water
Juice comes out of the spout
under high pressure or escapes
from under the cover.
The speed you use is to
high
You use excessive force
working with the pusher
Decrease the speed by mov-
ing the switch to “1” position
Reduce the pressure on the
pusher.
Wipe the case with damp fabric. It is forbidden to immerse a juice extractor in water or to wash it
out under water stream.
With the lapse of time such products as carrots or beet can paint the details of device.
There is nothing terrible. These details can be washed in a bleaching solution (do not
use abrasives) right after use.
STEP THREE