Bulletin No. DA30D-A
Effective 2018-11-02
Drawing No. LP1078
-6-
BATTERY
&
TIME
KEEPING
A battery is used to keep time when the unit is without power. The
battery of a DAx0D unit does not affect the unit’s memory, all
configurations and data is stored in non-volatile memory.
Changing
the
Battery
To change the battery of a DAx0D, first remove power to the unit.
Remove the SD card if one is installed. Insert a small screwdriver into the
slot provided on the battery holder and pry the battery holder with battery
out of the unit. Remove the old battery from the plastic holder and replace
it with a new battery. Make sure the orientation of the battery is correct
and as shown in the diagram.
Re-install the battery holder with battery into the DAx0D unit. Enter
new date and time using Crimson 3.1 software.
CAUTION
: Lithium battery. Danger of explosion if battery is
incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacturer.
Please note that the old battery must be disposed of in a
manner that complies with your local waste regulations. The
battery must not be disposed of in fire, or in a manner whereby
it may be damaged and its contents could come into contact
with human skin.
WARNING - EXPLOSION HAZARD - DISCONNECT POWER AND
ENSURE THE AREAS IS KNOWN TO BE NON-HAZARDOUS
BEFORE SERVICING/REPLACING THE UNIT AND BEFORE
INSTALLING OR REMOVING I/O WIRING AND BATTERY.
+
-
To maintain UL rating, battery must
be replaced with one listed in the
Specifications.
