Copyright © 2003 Redline Tuning LLC. All Rights Reserved.
A. The vehicle fender has a symmetrical structure. Repeat Steps 3-7 to install the passenger fender bracket. Take
your time.
A.
On the hood hinge,
locate the center end of the location
shown to the right. You will marking this hole with a center
punch (the upper center point of the indentation on the hinge).
Step 8 - Repeat steps 3-7 and install the passenger side fender bracket.
Step 9 - Position and mark hole for hood ball-stud.
2
008+ M
itsu
b
is
h
i Lanc
er Quic
k
LIFT Insta
ll
ation Gui
d
e
A. Drill the hole at the marked position using a sharp
5/16" drill bit.
Tip:
First drilling a smaller pilot hole will make the final
5/16" hole much easier to drill.
Step 10 - Drill hole using 5/16" drill bit.
B. Using a center punch, tap the center of the mark you
just made - this will help guide the drill bit in Step 10.
A. Using a color matching paint, touch
up the area where you just drilled the
hole.
B. Place one washer onto ball-stud
shaft, then insert into hole. Ball-stud
should point inward or toward the
engine with the lock nut on outside.
Place the lock-nut onto the ball-stud
shaft . Tighten using 1/2" wrenches or a
deep well 1/2" socket on ball-stud and
a wrench on the locking nut.
Step 11 - Attach the ball-stud to the hood hinge.
