4
Always use the dry soft cloth to clean the device. If there is too much dust, please use the water
to dilute the mild detergent first and then use it to clean the device. Finally use the dry cloth to
clean the device.
Please put the dustproof cap to protect the CCD (CMOS) component when you do not use the
camera.
ACCESSORIES
1.
ELEC TRICAL SAFETY
All installation and operation here should conform to your local electrical safety codes. The
power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the Limited
power source is rated 12V DC or 24V AC in the IEC1 -60950.
Before you replace the SD card, please unplug the power cable and then remove the shell. We
assume no liability or responsibility for all the fires or electrical shock caused by improper
handling or installation. We are not liable for any problems caused by unauthorized
modifications or attempted repairs.
2.
INSTALLATION
Do not apply power to the IP camera before completing installation.
Do not put object on the IP camera.
3.
ENVIROMENT
This series IP camera should be installed in a cool, dry place away from direct sunlight,
inflammable, explosive substances and etc.
The working temperature ranges from 10- to 60+. Please keep it away from the
electromagnetic radiation object and environment.
Please keep the sound ventilation.
Do not allow the water and other liquid falling into the RLC.
Thunder-proof device is recommended to be adopted to better prevent thunder. The grounding
studs of the product are recommended to be grounded to further enhance the reliability of the
camera.
4. DAILY MAINTENANCE
Current series RLC has no power button. Please unplug all corresponding power cables before
your installation.
Do not touch the CCD or CMOS part; you can use the blower to clean the dust on the surface of
the lens. You can use the dry cloth with some alcohol to clear if necessary.
Please keep the dustproof cap back to protect the CCD or CMOS part if the IP camera does not
work for a long time.
