25
Use slotted screwdriver to fasten the screw near the focusing ring and then turn counter
clockwise to move the focusing ring out for several millimeters.
Now you can focus manually and check the video is clear or not. If you can’t see the
clear video, you can adjust via the flange-back. After you completed the focus setup, use
the slotted screwdriver to fix the screw firmly. Fasten the focusing ring. Now the
installation completed.
3.1.3. REMOVE LENS
Please follow the steps listed below to remove lens. The interface is shown as in Figure
3-3. Turn the lens counter clockwise and then remove it from the camera.
Unplug the auto lens cable socket from the auto lens connector. If you are using the
manual aperture lens, please skip to the following step. If there is no lens, please put the
CCD protection cap back to protect the CCD.
3.2. SD CARD
3.2.1. INSTALLATION
Please follow the steps listed below to install SD card. The interface is shown as in Figure
3-4 and Figure 3-5. Use the screwdriver to loosen the SD card protection screw in the
rear panel, and then remove the SD card protection cap from the camera. Install the SD
card to the camera according to the proper installation position. Put the SD card
protection cap back. Use the screwdriver to fix the SD card protection cap screw firmly
to secure the SD card protection cap in the camera.
