16
Sending SMS to enter the numbers:
In order to store numbers and settings in the SBX-3 SIM card, send an SMS in this format:
TSST$MAIN_A:0733123456&USER_A:0706123456&SEARCH_A:06123456&
Where 0733123456 should be changed to the telephone number of the SIM
card 0706123456 should be changed to the primary users phone number
06123456 should be changed to the last 8 digits of the primary users phone number
When the SBX-3 has received the SMS the numbers are entered into the SIM card, the yel-
low LED will go off while the other LEDs will be on or blinking for a couple of minutes. When
both the yellow GSM and green SYS light is blinking the SBX-3 is ready for use.
Using a mobile phone or SIM card reader to enter the numbers:
See the description for the mobile phone or SIM card reader.
We recommend the use of Internet or SMS to enter the numbers for the following reasons:
Some mobile phones can not enter numbers directly on the SIM card and may add a cha-
racter to the name for indicating the type of number. Some SIM card readers has problem
reading certain types of SIM cards.
When reentering the SIM card into the main unit, the unit has to perform a system reset
in order to read the SIM card. To do this, disconnect the wires 7 (black), 10 (red) and 12
(black). Wait at least 10 seconds and then connect 7, 10 and 12 in that order. It will take
one minute, then the LEDs will start to blink indicating that the SBX-3 is ready for use.
Function test
Call the SBX-3 using the primary users mobile phone. The SBX-3 will deny the call resulting in
a busy tone or an error message from the operator.
An SMS with position and status information will arrive to the primary users mobile phone,
usually within a minute.
Summary of Contents for SBX-3 Series
Page 21: ... AxTech AB 2005 v1 87 ...
