Redexim VERTI-CUT 2000, User Manual And Parts Book

Page: 4 / 19

4
Regularly check any hydraulic hoses and replace these if damaged or show signs of
ageing. The replacement hoses must meet the manufacturer’s technical
requirements.
If present, the hydraulic system must be depressurised at all times before performing
any activities on it.
The Verti-Cut may NEVER be used if the safety stickers are not present.
NEVER crawl underneath the Verti-Cut.
Tilt the Verti-Cut if required.
NEVER get off the tractor while the engine is still running.
The Verti-Cut must be blocked to prevent it from lowering/driving off/sliding away
when performing maintenance, adjustment and repair activities.
Always switch off the tractor engine, remove the tractor ignition key and
disconnect PTO shaft
when performing maintenance, adjustment and repair
activities
. (Fig.2)
Fig. 2
Only use original Verti-Cut parts for maintenance or repair activities
in relation to the safety of the machine and user.
Repairs to the Verti-Cut must be performed by authorised, technical staff.
Maintain a repairs record.
(5) In addition to the instructions in this user manual, the prevailing safety standards and
Occupational Health and Safety regulations must be observed.
The governing procedures of the traffic regulations apply to use on public highways.
Transport of persons is not permitted!
Do not use the Verti-Cut during hours of darkness, heavy rain/storm or on slopes with
a gradient greater than 20 degrees.
(6) All persons using the Verti-Cut must be familiar with all functions and operational
elements of the machine prior to commencing the activities.
Connect the Verti-Cut to the pulling vehicle as stated in the instructions.
(Injury hazard!)