12
6.0 TRANSPORTING
THE
‘SPEEDSEED WALK BEHIND’
2
1
Figure 10
Transporting the machine is done as follows
(see Figure 10)
:
!! Make sure that the ‘Speedseed Walk Behind’ is blocked well and cannot
move on its own accord !!
!! Switch off the ‘Speedseed Walk Behind’ before making adjustments !!
1.
Lift the handle (1) of the brush at the rear of the machine so that the brush is
raised.
2.
Turn the spindle (2) at the front of the machine so that the machine tilts backward
and the spike roller gets off the ground.
7.0 GENERAL
REMARKS FOR USING THE ‘SPEEDSEED WALK
BEHIND’
The following are some general remarks/tips for using the ‘Speedseed Walk Behind’:
A field can be worked two or three times in different directions in order to
obtain a higher sowing density.
Do not make sharp turns.
If a hard object gets into the bottom of the machine, it could cause burrs or
damage to the spike component. Try to file these burrs off or replace the spike
component.
8.0 USING THE ‘SPEEDSEED WALK BEHIND’
Before using the ‘Speedseed Walk Behind’ in a location, you should check the following
items:
1.
Are there loose objects in the field? First remove these objects.
2.
Are there slopes? The maximum slope is 20 degrees for this machine.
