16
1. Chain for traction drive (5)
-
Remove the protective cover (1) by loosening the screws (2).
-
Loosen the screws (6) and tighten the axle shaft to the rear. Pay attention
to uniform tightening on the left, middle and right bearing. Tighten the
screws (6).
-
Attach the protective cover (1) with the screws (2).
2. Chain for conveyor belt and brush drive (3)
-
The chain is automatically tightened with the tension spring (4). Please
check the pull of the spring regularly and replace it if necessary.
3. Chain spraying (every 30 operating hours)
-
Spray the chain of the conveyor belt and the brush drive (3) and the chain
of the traction drive (5) with
silicon or teflon spray
.
V-belt tightening
-
Remove the protective cover (1) by loosening the screws (2).
-
Loosen the 4 fastening screws (3) of the engine and the counter nut (4).
-
Tighten the V-belt by moving the engine with the adjustment screw (5).
-
Tighten the 4 fastening screws (3) and the counter nut (4).
-
Attach the protective cover (1) with the screws (2).
Summary of Contents for RINK SP950
Page 14: ...14 Replacing the conveyor belt...
