10 |
P a g e
How to operate the heater
NOTE:
The heater may emit a slight harmless smoke when first used. This smoke is a normal condition
caused by initial heating of the infrared element. It will occur only briefly and is not harmful.
Un-package heater:
cut open tape area, fold back flaps and gently turn entire box upside down. Lift
box from Styrofoam packing. Remove Styrofoam, turn upright.
We recommend keeping the
package for off-season storage and any transporting needs.
Position:
Find a level and unobstructed location to place the unpackaged heater.
Plug
in:
Plug the power cord directly into an unused grounded 120 volt 15 amp or higher circuit
receptacle.
Set ON/OFF switch to ON
: Press down the switch located on the rear of the heater to the ON
position (I). This provides electricity to the unit.
Set POWER to ON
: Press the POWER button on the LCD panel (or remote control) to turn on the
unit. The Actual Temperature will be displayed. NOTE: The heating function will still not be active.
You must press the HEATER on/off button (see below) to activate the heating function.
Heater ON/OFF:
Press the HEATER power button to turn on or off the heating function of the heater.
The fan will not operate until the heating element has reached a temperature high enough to begin
the warming process. During the period that the fan will not run, and the message “HEATING UP”
will show on the LCD display to indicate that the heater is heating up.
