Battery
Installing the Battery:
We highly recommend that you put on protective eyewear, gloves and a long sleeved
shirt, during this part of the installation process
1. Remove the battery and the clear white fluid filled container from the box that is attached to
the crate.
2. Remove the protective tape from the top of the battery
3. The white fluid filled container is called electrolyte fluid.
Be very careful when working
with this.
Slowly remove the black top from the electrolyte container, but keep the top close by,
as we will be using it again.
Note;
DO NOT
break the thin metal foil
on the fluid once you
remove the black top.
4. Take the bottle of electrolyte and turn them upside down and place them on the holes on top of
the battery. Once you have done this and made sure that all holes are matched up, push down
firmly to break the thin metal foil.
5. Use a knife to slit a small hole on the bottom of each electrolyte container so that the fluid will
drain into the battery. Once all containers have emptied, you can then remove the plastic
container and throw it away. Make sure you keep this out of reach of children.
6. Replace the black lid that you first removed from the electrolyte container and place it firmly
on top of the battery. Make sure it fits firmly and is securely pushed all the way down onto each
and every hold in the battery.
7. It is best to let the battery sit for about 15 minutes prior to installation into the ATV.
8. The battery will be installed behind the seat and there will be a specific space for placing the
Summary of Contents for KMX-50
Page 1: ...REDCAT KMX 50 MANUAL...
