4
RUNNING YOUR CAR
1
TURN ON THE RADIO CONTROLLER
2
TURN ON THE RECEIVER ON YOUR CAR
CAUTION
TO BIND THE RECEIVER TO THE RADIO CONTROLLER
Power Switch
Before running, make sure that the radio controller is bound with the receiver, which has been
done at factory. If the model is not responding to the controller, it is possible that the controller
and receiver are not bound, and you must perform the binding procedure following the
instructions below.
1)Turn on the receiver (3-in-1 unit) using the
power switch located on the side of the car.
(Note: Receiver and ESC are combined inside
the 3-in-1 unit.)
2) Hold the Bind(Pair) key and switch
on the power on the controller.
You must Hold the Bind(Pair) within
5 seconds of turning on the receiver.
3) The green indicator should flash, meaning
that the binding process is being performed.
4) Once both red and green indicator
are lit and not flashing, then your
receiver is bound to your radio
controller. The binding process is
complete.
Before using your car, make sure the radio controller has sufficient battery power.
If the battery power is too low it can lead to the loss of control of your car.
Always turn on the remote controller FIRST, and then the receiver.
