FAMILIARIZING YOURSELF WITH YOUR 2.4GHz RADIO SYSTEM
3
BATTERY INSTALLATION
NOTES:
A: Steering Wheel
B: Trigger
C: Battery Case
1: Steering Trim
2: Steering Reverse
3: Red Indicator
4: Power Switch
5: Steering Dual Rate
6: Throttle Trim
7: Throttle Reverse
8: Green Indicator
9: Bind(Pair) button
Your car is equipped with the new 2.4GHz radio system. Please read and understand all
instructions below before operating.
Steering Wheel:
Proportionally operates the models right and left steering control.
Battery Case:
Requires 3pcs of AA size batteries.
Power Switch:
Used to turn the radio controller ON/OFF
Steering Dual Rate Dial:
Allows you to change the amount of steering servo travel compared
to the amount of physical movement of the steering wheel.
Throttle /Steering Trims:
Used to adjust the center trim of the throttle/steering channel.
Steering Reverse:
Allows you to electronically switch the direction of steering servo travel.
For example, if you move the steering wheel to the right and the steering servo moves to the
left, flip the Steering Reverse Switch to make the steering servo move to the left.
Throttle Reverse :
Allows you to electronically switch the direction that the motor operates
in relation to the throttle trigger. For example, if you pull the throttle trigger to accelerate
forward, but the model goes in reverse,
flip the Throttle Reverse Switch to make the model accelerate forward.
Trigger:
Controls the speed and braking ability of your car. Pull it to accelerate, release it to
decelerate, and push it to brake. Pushing it a second time activates the reverse feature.
Indicators:
Shows battery power level. Green indicator flashing means battery power is low.
If both red and green indicators are flashing then the radio controller battery is too low to
control the model and you must replace with fresh batteries immediately.
Bind(Pair) button:
It is used to bind your 2.4GHz radio system.
1) Slide the battery cover as shown and install 3pcs of
AA size batteries, positioning the polarity as indicated.
2) Replace the battery cover after batteries are installed.
-Use batteries of same type.
-Remove batteries from the case if not in use.
-Always check the battery power.
-Dispose of exhausted batteries properly.
