Redback® A 6500A
Programmable Control System
Redback® A 6500A
Programmable Control System
www.redbackaudio.com.au
Redback® Proudly Made In Australia 21
Redback®
Programmable Control System
4.0 INITIAL POWER UP
THe A 6530 or A 6540 series wallplate is connected to the A 6505A as shown in figure 4.0. Once power is applied to the
A 6505A Serial Hub, the A 6530 or A 6540 series wallplate will power up a couple of seconds later. The screen will briefly
display the software revision and some dignostic information, before displaying the default testing screen which displays
six smiley face icons. These icons represent buttons and are labelled “SERIAL 1”, “SERIAL 2”, “IR LG POW”, “RELAY 1”,
“RELAY 2” and “RELAY 3”.
Fig 4.0
These buttons relate to the outputs of the A 6505A Serial Hub. When these buttons are pressed the corresponding out-
put’s LED will illuminate as shown in the A 6505A rear panel diagram of figure .
NOTE: The Serial 1, Serial 2 and IR LED’s will flash sparodically.
This Default configuration is useful for testing purposes.
Fig 3.9
This screen setup is not going to be applicable to any real world application. In the following section a Lecture Theatre Setup
is outlined.
Redback® A 6541
Redback® A 6505A
24V DC PLUGPACK
(MINIMUM 1A)
(Cat5/6 Cable 50m Maximum)
A 1052 IR REPEATER
RS232/
RS485
RS232/
RS485
RELAY CONTROLLED DEVICES
(CONTACTS MAX 2A)
CLOSING CONTACT
Relay OUT
1 2 3
RS485-1
RS232-1
IR
RS485-2
RS232-2
TO A 6500A
PIR T
rigger
+ _
Power
1 2
Out 1
Out 2
Out 3
DIP
SW
IR LED
RS485 2
Serial 2
RS485 1
Serial 1
N/C
N/O
CO
M
N/C
N/O
CO
M
N/C
N/O
CO
M
GND
B
A
GND
B
A
GND
TX
RX
GND
TX
RX
SERIAL 1
SERIAL 2
IR LG POW
RELAY 1
RELAY 2
RELAY 3