7
www.redbacklasers.com.au
Turning Laser On (Horizontal Operation)
Before the ARL516G
TM
can be powered up
for normal horizontal rotation the pendulum
locking knob first needs to be rotated to the
“ON” position, this disengages the protective
pendulum lock.
Now when the power button is pressed
the laser will be powered up and the head
of laser begins to rotate and after a couple
of seconds the magnetically dampened
pendulum will be self levelled.
If the laser emits a loud beeping sound
then the laser housing is setup outside self
levelling range, re-setup and try again.
Rotation Speed Settings
•
The ARL516G
TM
starts by default in rotation mode and so the rotation
button only needs to be pressed when switching from scan
mode back to rotation. Whilst rotating the speed of rotation can be
changed by pressing the up and down arrow buttons on the keypad
or remote . Rotation speed will effect receiver performance
at different distances and also help visibility of the laser beam when
used indoors.
Turning Laser On (Vertical Operation)
The ARL516G
TM
can be used on its side for
vertical rotation and alignments. In this
orientation the Pendulum lock must remain
in the “OFF” locked position, levelling of the
laser is manual and is achieved by levelling
off the bubble vial built into the keypad
using the “Levelling Knob” see page 4.
Power up with power button . Note
the power button on the remote is to turn
off ONLY.
Summary of Contents for ARL516G
Page 1: ......
