8
EGL624
TM
OPERATING INSTRUCTIONS cont.
Setting Slope/Grades
(refer to diagram page 4)
The EGL624
TM
can be used to set grades. In Slope (Grade) Mode you can set
a Grade in either the X or the Y Axis of up to 8% see the markings on top of
laser for axis alignment. With the EGL624 both “TILT” and “V-W-S” modes
can be used. The EGL624 is dual grade capable so a grade can be set on the
X and Y axis simultaneously, however, only when in manual mode page 10.
•
Turn the laser on, allow to level and begin rotating.
•
On either the key pad of the laser or on the remote control a short press
of the Slope (Grade)/Manual Mode button will activate slope mode
indicated by LED and the X LED will also illuminate. Note a long press
will enter Manual mode see page 10.
•
Select the axis you wish to grade by again pressing this same button
and the selected X or Y axis LED will light. A long press when already
in slope mode will exit back to normal levelling.
•
Move the laser plane on the selected axis up or down using the Slope
Grade Direction buttons . For dual grade use manual mode
see page 10.
•
To reset and re-level press and hold the Slope Grade button .
www.redbacklasers.com.au
Summary of Contents for EGL624
Page 1: ......
