COPYRIGHT © 2016 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
955-0116_V6.1, REV-U | 160
INSTALL THE MEDIA BAY
WARNING:
Before installing or removing the media bay, you MUST turn off the camera.
REQUIRED TOOL:
T10 TORX driver
1. Turn off the camera.
2. Place the media bay on the camera, so that the mounting holes of the media bay align with the screw holes
of the camera.
3. Use a T10 TORX driver to tighten the four (4) captive screws by about two (2) turns in a cross pattern (“X”
pattern). DO NOT FULLY TIGHTEN.
4. Tighten the four (4) captive screws evenly. DO NOT exceed 70 in-oz, or damage may occur.
WARNING:
DO NOT OVERTIGHTEN.
CAMERA DOES NOT RECOGNIZE OLPF
SYMPTOM
Your camera does not recognize the OLPF.
POTENTIAL RESOLUTIONS
Reinstall the OLPF. For more information, go to
“Swap an Interchangeable OLPF” on page 42
Install a different OLPF.
If your camera still does not recognize the OLPF, please submit a Technical Support request at
CAMERA KEEPS PROMPTING BLACK SHADE MESSAGE
SYMPTOM
Your camera keeps prompting you to black shade the camera.
POTENTIAL RESOLUTIONS
Ensure that you complete the sensor calibration process. For more information, go to
Go to
Menu
>
Settings
>
Maintenance
>
Calibrate
and select
user1 Calibration Map.
Click
Set
.
Go to
Menu
>
Settings
>
Maintenance
>
Calibrate
and delete all user-created calibration maps. Then perform
a Reset Defaults. For more information, go to
.
MOUNT TYPE: UNKNOWN
SYMPTOM
The error message “Mount type: Unknown” displays in
Menu
>
Settings
>
Setup
>
Lens
.
POTENTIAL RESOLUTIONS
Ensure that a lens mount is installed.
Ensure that a compatible lens mount is installed.
NOTE
: Third-party lens mounts are not compatible with the camera.
