4. Place the W.M.D. against the Tactical Plate so that the guide pin and 1/4-20 screw each align with a 1/4-20 screw
hole.
5. Tighten the W.M.D. 1/4-20 thumbscrew.
WARNING:
DO NOT OVERTIGHTEN.
Figure: Push and Turn Thumbscrew
MOUNT THE W.M.D. TO A V-MOUNT RECEIVER
The W.M.D. ships with a V-LOCK to mount the W.M.D. to most industry-standard female v-mount receivers.
1. Align the V-LOCK on the back of the W.M.D.
2. Use a Phillips
®
#1 screwdriver to install three (3) M3 x 0.5 x 8 mm flathead screws that attach the V-LOCK to the
W.M.D. Fully tighten.
WARNING:
DO NOT OVERTIGHTEN.
3. Use a Phillips #1 screwdriver to remove the three (3) M3 x 0.5 x 8 mm flathead screws, when finished.
Figure: W.M.D. Rear (V-Lock Installed)
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
2 4
RED 3-AXIS SYSTEM OPERATION GUIDE
