8
Alternate Controls [DIV]
Press and hold the
ON/[DIV] footswitch to adjust tap divisions and alternate parameters. Alternate func-
tions are labled
[DIV] in the following sections.
To access
[DIV] settings:
1. Start with the Particle enabled (blue light on)
2. Hold the
ON/[DIV] footswitch until the LED changes to yellow (the pedal will briefly go into bypass)
3. While holding the
ON/[DIV] footswitch, adjust the knobs and mode switch as desired
4. Release the
ON [div] footswitch to store the settings
BLEND
Adjusts the wet/dry mix, from 100% dry to 100% wet. The dry signal stays at unity gain until 12:00, so
there will be a slight volume boost when the wet and dry signal are combined.
FDBK
Adjusts audio feedback (repeats).
[DIV] Feedback tone (see "Feedback Lowpass Filter (Tone)" on page 10).
CHOP
Adjusts grain size from 7:00 to 12:00. Above 12:00, sets the freeze threshold (see "Freeze" on page
9).
[DIV] sets grain size to a note division.
MODE
Selects one of the delay or pitch modes and which of the parameters are controlled by the DELAY/PITCH
and PARAM knobs.
[DIV] sets delay time to a note division.
DELAY/PITCH
Sets the delay time or pitch shift amount, depending on mode. The pitch shift range is ±1 octave, with no
shift at 12:00.
[DIV] sets delay time to a note division.
PARAM
Adjusts a mode-specific parameter.
Summary of Contents for PARTICLE 2
Page 1: ...1 PARTICLE Owner s Manual Detroit MI www redpandalab com ...
Page 34: ...34 ...
Page 35: ...35 ...
