10
REPEATING LAST-PLAYED AUDIO
The Particle is always listening to your signal, even in analog bypass mode. This allows you to repeat a
phrase that you just played. With the Particle in bypass, set CHOP to 100% the DELAY knob to the desired
repeat time, or use tap tempo When you click the ON footswitch, the Particle will enter freeze mode the
the last segment of audio played.
TAP - FREEZE
Since the left footswitch is used for both setting delay time (tap) and freeze (hold), you can use it to set
the freeze time on the fly, in all modes. Tap once, wait, and then press and hold the footswitch. The
length of the frozen segment will depend on the tap division.
Feedback Lowpass Filter (Tone)
You can adjust the cutoff frequency of the feedback lowpass filter to control the brightness of the re-
peats. The setting is stored in presets, and remembered when power is removed.
To adjust the feedback lowpass filter:
1. Start with the Particle enabled (blue light on)
2. Hold the
ON [div] footswitch until the light blinks (the pedal will briefly go into bypass)
3. While holding the
ON [div] footswitch, adjust the FDBK knob for the desired tone
4. Release the
ON [div] footswitch to store the setting
Realtime adjustment is available via MIDI continuous controller messages.
Summary of Contents for PARTICLE 2
Page 1: ...1 PARTICLE Owner s Manual Detroit MI www redpandalab com ...
Page 34: ...34 ...
Page 35: ...35 ...
