9
Controls
MIX
Adjusts the wet/dry mix, from 100% dry to 100% wet.
CRUSH
Adjusts the bit depth from 24 bits down to 1 bit, including fractional bit depths.
FREQ
Adjusts the sampling rate, from 48,000 Hz down to 110 Hz. The sampling rate can be modulated by the
LFO or envelope follower.
FILTER
Adjusts the cutoff frequency of the 4-pole filter. The cutoff can be modulated by the LFO or envelope fol-
lower. Use our web editor or MIDI to select the filter as the modulation destination. Resonance can also
be adjusted using the editor or MIDI. Both settings are saved in presets.
WAVE (LFO)
LFO waveform and wave modulation selection. The waveform LEDs indicate the current selection:
●○○○
Triangle wave LFO
○●○○
Square wave LFO
○○●○
Random LFO
●○○●
Wavefolder
○●○●
Wave window
○○●●
Waveshaper
RATE (LFO)
LFO modulation rate. The waveform LED will blink at the modulation rate. The LFO can be synced to tap
tempo or MIDI clock. It syncs to quarter notes by default, but a variety of note divisions can be set using
the web editor or MIDI. The modulation note division is stored in presets and remembered when power
is off.
The
AUX footswitch can be configured to freeze the modulation (LFO hold) or turn it on/off.
The LFO rate can be set to audio frequencies. It is often useful to lower the modulation
DEPTH when
using higher modulation rates.
DEPTH (LFO)
LFO modulation depth and waveshaping intensity. Turn fully counter-clockwise to turn off modulation.
Depending on the
WAVE setting, the DEPTH control modifies:
