12
Chapter 2 Installation and Assembly
Drawing No. LP1106
DIN Rail Mounting and Removal
Revision B
ST-IPm-8460
SixTRAK IPm
®
RTU/Controller
DIN Rail Mounting and Removal
The Sixnet Series ST-IPm-8460 units can be snapped onto a standard DIN rail (EN50022) or screwed directly to a flat
panel. Refer to Figure 2.1 to properly mount the ST-IPm-8460 unit.
Note:
Allow enough room to route Ethernet copper or fiber optic cables.
Figure 21 Mounting and Removal Instructions
1
Mounting
2
Recommended DIN rail mounting steps:
1. Hook the top of the unit over the DIN rail.
2. Push the bottom of the unit towards the DIN rail until it snaps into place.
Removal
Recommended DIN rail removal steps:
A. Insert screwdriver into DIN clip and pry until the bottom of the unit releases from the DIN rail.
B. Unhook the top of the unit and remove it from the DIN rail.
A
B